NeuroTrac PelviTone Pelvic Floor Rehabilitation Stimulator

Neurotrac Pelvitone specifications:

1. 1. Dual channel: individually isolated circuits.

2. 2. Amplitude: 0-90 mA into 500 Ohm load; actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 86 mA, at 1500 Ohms load the maximum will be limited to 65 mA.

3. Type: Constant current,

maximum output voltage 180 Volts +10 / -30 Volts

4. Waveform: Symmetrical, rectangular bi-phasic with zero DC

current.

5. Selectable pulse width: 50 ìS – 330 ìS [2% accuracy].

6. Pulse Rate selection: in the continuous mode 2 – 100 Hz

[2% accuracy].

7. Time duration of the treatment selectable: 1 minute to 90 minutes.

8. Low Battery Indicator: If the battery goes below 6.9 volts +/- 0.2

volts the battery symbol will flash on/off once every second.

9. Open Electrode Detect: If an open circuit is detected at the

output of channel A or B the output current will be reset at zero.

10. Ramp up time 0.1 - 9.9 seconds.

11. If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn

on.

12. Physical dimensions: 134 x 69 x 29.7 mm.

13. Weight: 0.18 KG with battery.

14. Environmental Conditions for use:

+10 to +30 degrees Centigrade. 0-90% Humidity.

15. Environmental conditions for storage & transport:

-10 to +50 degrees Centigrade. 0-90% Humidity.